Blazer 4WD V6-4.3L VIN X (2005)
7. Remove the brake rotor and wheel bearings, 2 wheel drive vehicles only.
8. Inspect the brake rotor.
9. Inspect the brake caliper.
10. Refinish the rotor if necessary.
Installation Procedure
Notice: Whenever the brake rotor has been separated from the wheel bearing flange, clean any rust or foreign material from the mating surface of the
rotor and flange with the J42450 hub cleaning kit. Failure to do this may result in increased lateral runout of the rotor and brake pulsation.
1. Using the J42450-A, clean the hub flange, 4 wheel drive vehicles.
2. Install the brake rotor, 4 wheel drive shown.
