Blazer 4WD V6-4.3L VIN X (2005)
3. Remove the hub and bearing assembly.
4. Remove the splash shield.
Installation Procedure
1. Install the splash shield.
2. Install the hub and bearing assembly.
3. Install the tire and wheel assembly.
4. Lower the vehicle.
5. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
6. Slowly release the brake pedal.
7. Wait 15 seconds, then repeat steps 5-6 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
Disc Brake Backing Plate Replacement - Rear
Disc Brake Backing Plate Replacement - Rear
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
