Blazer 4WD V6-4.3L VIN X (2005)
^
Install a large C-clamp over the top of the caliper housing and against the back of the outboard pad.
^
Slowly tighten the C-clamp until the piston is fully seated in the brake caliper bore.
^
Remove the C-clamp from the caliper.
7. Remove the brake caliper hose bolt from the brake caliper.
8. Remove the 2 metal gaskets from the brake caliper bolt. These gaskets maybe stuck to the brake caliper and/or the brake hose end.
9. Discard the 2 metal gaskets.
10. Plug the opening in the front brake hose in order to prevent excessive brake fluid loss and contamination.
11. Remove the brake caliper mounting bolts.
12. Remove the brake caliper.
13. Remove the brake pads from the brake caliper.
14. Remove the brake caliper mounting bolt sleeves.
15. Remove the rubber O-rings.
