Blazer 4WD V6-4.3L VIN X (2005)
Important: When performing the following service procedure, DO NOT reuse the washers, replace them with new washers.
8. Install the front brake hose fitting, the 2 new gaskets and the brake hose fitting bolt.
Tighten the front brake hose bolt to 54 Nm(40 ft. lbs.).
9. Fill the brake master cylinder to the proper level.
10. Bleed the brake caliper.
11. Inspect the brake system for leaks.
12. Install the tire and wheel assembly.
13. Lower the vehicle. Refer to Vehicle Lifting.
Brake Caliper Replacement - Front (Dual Piston)
Brake Caliper Replacement - Front (Dual Piston)
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the brake caliper hose bolt from the brake caliper.
4. Remove the 2 copper gaskets from the brake caliper bolt. These gaskets maybe stuck to the brake caliper and/or the brake hose end.
5. Discard the 2 copper gaskets.
6. Plug the opening in the front brake hose in order to prevent excessive brake fluid loss and contamination.
7. Remove the brake hose and washers from the brake caliper.
