Blazer 4WD V6-4.3L VIN X (2005)
13. Notice: Any time the transmission and the engine oil pan are off of the engine at the same time, install the transmission before the oil pan. This is
to allow for the proper oil pan alignment. Failure to achieve the correct oil pan alignment can result in transmission failure.
Install the transmission to oil pan bolts.
^
Tighten the transmission to the oil pan bolts to 47 Nm (35 ft. lbs.).
14. Install the access plugs for the oil pan rear nuts.
15. Install the stud holding the bracket for the starter wire harness and if equipped, the transmission oil cooler pipes.
^
Tighten the bracket stud to 9 Nm (80 inch lbs.).
16. Install the remote oil filter pipe adapter.
17. Install the bolt holding the oil filter inlet and outlet hose clip to the oil pan.
^
Tighten the hose clip bolt to 10 Nm (88 inch lbs.).
