Blazer 4WD V6-4.3L VIN X (2005)
28. Connect the following electrical connectors:
^
The fuel meter body assembly (1)
^
The EVAP canister purge solenoid valve (2)
^
The manifold air pressure (MAP) sensor (3)
29. Connect the following electrical connectors:
^
The ignition coil (2)
^
The ignition control module (ICM) (1)
^
The generator (4)
30. Connect the power brake booster vacuum hose.
31. Connect the vacuum hose to the intake manifold, if equipped with A/C.
32. Install the water pump inlet hose to the intake manifold.
33. Install the heater hose to the intake manifold.
34. Install the radiator inlet hose to the thermostat housing.
35. Install the cruise control cable, if equipped to the bracket and the throttle shaft.
