Blazer 4WD V6-4.3L VIN X (2005)
Door Switch: Service and Repair
Door Jamb Switch Replacement - Rear
DOOR JAMB SWITCH REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Caution Refer to Battery Disconnect Caution in Service Precautions. Disconnect the battery negative cable.
2. Use a flat bladed tool in order to remove the door jamb switch from the rear door hinge-pillar.
3. Disconnect the electrical connector.Tape the wires to the body in order to prevent them from dropping into the rear door hingepillar.
INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the door jamb switch to the rear door hinge-pillar.
3. Connect the battery negative cable.
