Blazer 4WD V6-4.3L VIN X (2005)
7. Disconnect the electrical connectors from the underhood electrical center .
8. Remove the underhood electrical center from the vehicle.
INSTALLATION PROCEDURE
1. Connect the electrical connectors to the underhood electrical center.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the electrical connector to the underhood electrical center bolts to 7 N.m (62 lb in).
2. Install the bolts that attach the underhood electrical center to the underhood electrical center support bracket.
Tighten the underhood fuse block to the underhood electrical center support bracket bolts to 7 N.m (62 lb in).
3. Attach the battery positive cable with bolt to the underhood electrical center.
Tighten the battery positive cable to the underhood electrical center bolt to 10 N.m (89 lb in).
