Blazer 4WD V6-4.3L VIN X (2005)
6. Install the accelerator cable onto the throttle body.
NOTE: Check for unrestricted and complete throttle opening and closing positions by operating the accelerator pedal in order to prevent vehicle
damage. Also check for poor carpet fit under the accelerator pedal. Throttle should operate freely without bind between full closed and wide open
throttle.
7. Install the cruise control cable onto the throttle body.
8. Connect the TP sensor harness connector.
9. Connect the IAC valve harness connector.
10. Install the air cleaner adapter stud.
Tighten the stud to 8 N.m (71 lb in).
11. Install the air cleaner outlet duct.
12. Use the following procedure in order to inspect the accelerator pedal operation.
1. Turn ON the ignition, with the engine OFF.
2. Use a scan tool in order to observe the parameter for the TP sensor.
3. Depress the accelerator pedal to the floor.
4. Release the accelerator pedal.
5. Verify the throttle position has gone from 0-100 percent and back to 0 percent.
IMPORTANT: The accelerator pedal should operate freely without binding between closed and wide open throttle (WOT).