Blazer 4WD V6-4.3L VIN X (2005)
3. Install the transfer case brace, if equipped.
4. Install the transfer case brace bolts.
^
Tighten the transfer case bolt at the engine to 47 Nm (35 ft. lbs.).
5. Install the transfer case brace bolt at the transfer case.
^
Tighten the transfer case bolt to 60 Nm (44 ft. lbs.).
6. Install the transfer case shield.
7. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case Motor/Encoder Replacement
Transfer Case Motor/Encoder Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield.
3. Remove the front propeller shaft.
4. Remove the motor/encoder electrical connector.
5. Remove the motor/encoder mounting bolts.
6. Remove the motor/encoder assembly.
7. Remove the motor/encoder gasket.
Installation Procedure
