Blazer 4WD V6-4.3L VIN X (2005)
1. Important: The motor/encoder gasket does not have to be replaced if the motor/encoder is being removed from the transfer case for other service
procedures. Replace the motor/encoder gasket only if damaged. If the motor/encoder is being replaced, a new gasket will come with the
replacement motor/encoder.
Install the motor/encoder gasket.
2. Important: When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper installation.
Install the motor/encoder to the transfer case.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install motor/encoder mounting bolts.
^
Tighten the motor/encoder mounting bolts to 20 Nm (15 ft. lbs.).
4. Install the motor/encoder electrical connector.
5. Install the transfer case shield.
6. Lower the vehicle. Refer to Vehicle Lifting.
