Blazer 4WD V6-4.3L VIN X (2005)
16. Remove the shim washer (1).
17. Remove the old oil seal.
ASSEMBLY PROCEDURE
1. Line up the square-cut hole in the vane wheel for the CMP sensor.
NOTE: Refer to Distributor Driven Gear Can Be Installed in Multiple Positions Notice in Service Precautions.
2. Insert the sensor into the housing.
3. Install two new screws for the camshaft position (CMP) sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2.2 N.m (19 lb in).