Blazer 4WD V6-4.3L VIN X (2005)
Tie Rod: Service and Repair
Tie Rod Replacement (4WD)
^
Tools Required
-
J 6627-A Tie Rod Puller
-
J24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Raise and suitably support the vehicle with safety stands. Refer to Vehicle Lifting.
2. Remove the cotter pin from outer tie rod ball stud nut.
3. Remove the outer tie rod ball stud nut.
4. Remove the inner tie rod ball stud nut.
Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result
which will cause premature failure of the joint.
Important: Use the proper tool in order to separate all tie rods and ball joints.