Blazer 4WD V6-4.3L VIN X (2005)
2. Important: When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper installation.
Install the motor/encoder to the transfer case.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install motor/encoder mounting bolts.
^
Tighten the motor/encoder mounting bolts to 20 Nm (15 ft. lbs.).
4. Install the motor/encoder electrical connector.
5. Install the transfer case shield.
6. Lower the vehicle. Refer to Vehicle Lifting.
