Blazer 4WD V6-4.3L VIN X (2005)
14. Remove the 2-4 servo assembly from the transmission.
15. Inspect the 4th apply piston, the 2-4 servo converter, 2nd apply piston, and the piston inner housing for these defects:
^
Cracks
^
Scoring
^
Burrs and nicks
Installation Procedure
1. Install the new seals on the pistons and the servo cover.
2. Lubricate the seals with clean transmission fluid.
3. Install the 2-4 servo assembly into the 2-4 servo bore.
4. Install the servo cover and O-ring seal.
5. Install the J 29714-A.
6. Tighten the bolt on the J 29714-A in order to compress the servo cover.
7. Install the servo cover retaining ring.
8. Remove the J 29714-A from the oil pan flange.
9. Notice: Refer to Fastener Notice in Service Precautions.
Install the oil pan bolt.
^
Tighten the oil pan bolt to 11 Nm (97 inch lbs.).
10. Connect the oil cooler lines to the transmission, if removed.
11. Raise the transmission into place.
12. Remove the drain pan from under the vehicle.
13. Install the exhaust manifold pipe.
14. Install the transmission support.