Blazer 4WD V6-4.3L VIN X (2005)
Seals and Gaskets: Service and Repair
Filler Tube and Seal Replacement
Filler Tube and Seal Replacement
Removal Procedure
1. If the vehicle is equipped with a 2.2L engine, remove the bolt securing the dipstick to the exhaust manifold.
2. Remove the transmission oil level indicator.
3. Raise the vehicle. Refer to Vehicle Lifting.
4. If the vehicle is equipped with a 2.2L engine, proceed to step 7.
5. If the vehicle is equipped with a 4.3L engine, remove the exhaust manifold pipe.
6. Remove the rear propeller shaft.
7. Support the transmission and transfer case, if equipped, with a suitable jack.
8. Remove the transmission support.
9. Lower the transmission to gain access to the bolt securing the filler tube to the transmission torque converter housing.
10. Remove the bolt securing the filler tube to the torque converter housing.
11. Remove the filler tube and seal from the vehicle.
Installation Procedure
1. Install a new seal into the transmission case.
