Blazer 4WD V6-4.3L VIN X (2005)
2. Lubricate the seal with transmission fluid and install the filler tube into the seal.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the bolt securing the filler tube to the transmission torque converter housing.
^
Tighten the bolt to 47 Nm (35 ft. lbs.).
4. Raise the transmission.
5. Install the transmission support.
6. Remove the transmission jack.
7. If the vehicle is equipped with a 2.2L engine, proceed to step 9.
8. Install the rear output shaft.
9. Install the exhaust manifold pipe.
10. Lower the vehicle.
11. If the vehicle is equipped with a 2.2L engine, install the bolt securing the dipstick to the exhaust manifold.
12. Install the bolts securing the oil level indicator tube to the engine.
^
Tighten the bolts to 47 Nm (35 ft. lbs.).
13. Install the transmission oil level indicator.
14. Fill the transmission to the proper level with DEXRON III transmission fluid.
