Blazer 4WD V6-4.3L VIN X (2005)
Shift Cable: Adjustments
Automatic Transmission Range Selector Cable Adjustment
1. Apply the park brake.
2. Place the transmission range selector control lever (column or floor shift) into the NEUTRAL position.
3. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
4. Remove the positive assurance pin (2) from the bracket.
5. Release the cable lock tab (1).
6. Ensure that the transmission range selector lever is in the NEUTRAL position. Rotate the range select lever fully clockwise then counter clockwise
two detents.
7. Pull the cable end completely forward and release it. This allows the adjustment spring to position the cable to its most rearward position. Use care
not to pull the cable past the ball stud, this will result in a misadjusted cable.
8. If the adjustment body is not free to move under spring load, a proper adjustment can still be made. Push the adjustment body against the rearward
stop. Pull the cable end just far enough forward to install it to the ball stud.
9. Install the range selector cable end (2) to the range selector lever ball stud (1).
10. Depress the locking tab of cable (1) to set the adjustment.
