Blazer 4WD V6-4.3L VIN X (2005)
9. Install the J8614-01 as shown.
10. Remove the pinion nut while holding the J8614-0 1.
11. Remove the washer.
12. Install the J8614-2(2) and the J8614-3 (3) into the J8614-01 (1) as shown.
13. Remove the pinion yoke by turning the J8614-3 (3) clockwise while holding the J8614-01 (1).
Use a container in order to retrieve the lubricant.
Important: Do not damage the axle housing sealing surface.
14. Remove the pinion oil seal using a suitable seal removal tool.
Installation Procedure
