Blazer 4WD V6-4.3L VIN X (2005)
Seals and Gaskets: Service and Repair
Rear Drive Axle
Rear Axle Housing Cover and Gasket Replacement
Rear Axle Housing Cover and Gasket Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Drain the rear axle.
3. Remove the rear axle housing cover bolts (1).
4. Remove the rear axle housing cover (2) from the axle housing.
4.1.
Catch the oil in a drain pan.
4.2.
Remove any gasket material from the rear axle housing and/or the rear axle housing cover.
Installation Procedure
1. Install the rear axle housing cover (2) and a new gasket.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the rear axle housing cover bolts (1). Tighten the rear housing cover bolts in a crosswise pattern to 39 Nm (29 ft. lbs.).
3. Fill the rear axle. Use the proper fluid.
4. Lower the vehicle.
Drive Pinion Flange Yoke and/or Oil Seal Replacement
Drive Pinion Flange Yoke and/or Oil Seal Replacement
Tools Required
^
J8614-01 Flange/Pulley Holding Tool
^
J22388 Pinion Oil Seal Installer - Rear
^
J33782 Pinion Oil Seal Installer
^
J38694 Extension Housing Oil Pump/Seal Installer