Blazer 4WD V6-4.3L VIN X (2005)
22. Disconnect the right side wheel drive shaft from the differential carrier by placing a block of wood or a brass drift against the tripot housing.
Firmly strike the block of wood outward from the case with a hammer. Strike hard enough to overcome the snap ring pressure holding in the shaft.
23. Pull the axle straight out from the differential carrier.
24. Support the drive axle so as not to tear the boot.
Caution: To prevent personal injury and/or component damage, do not allow the weight of the vehicle to load the front wheels, or attempt to
operate the vehicle, when the wheel drive shaft(s) or wheel drive shaft nut(s) are removed. To do so may cause the inner bearing race to
separate, resulting in damage to brake and suspension components and toss of vehicle control.
25. Remove the drive axle.
Installation Procedure
Important: Do not lubricate or damage the differential carrier axle seals during installation.
