Blazer 4WD V6-4.3L VIN X (2005)
6. Rotate the inner race downward to insert the inner race into the cage.
7. Insert the cage (4) and inner race into the outer race (1).
8. Place a brass drift against the cage (1).
9. Tap gently on the brass drift in order to tilt the cage (1).
10. Install the first ball (2) when the cage tilts.
11. Repeat previous step to reinstall all of the balls.
12. Pack the CV joint seal and the CV joint assembly with the grease supplied in the kit. The amount of grease supplied in this kit has been
pre-measured for this application.
13. Place the new small swage clamp (2) onto the CV joint seal (1).
14. Place the large retaining clamp on the seal (1).
15. Position the small end of the CV joint seal (1) into the joint seal groove (3) on the halfshaft bar.
16. Position the outboard end of the halfshaft assembly(1) in J41048.
