Blazer 4WD V6-4.3L VIN X (2005)
Wiper Motor: Service and Repair
Wiper Motor Replacement - Rear
WIPER MOTOR REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Remove the wiper arm from the shaft.
2. Remove the nut and the spacer from the shaft.
3. Remove the interior trim panel.
4. Disconnect the electrical connector from the controller.
5. Remove two screws and the wiper motor from the vehicle.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the wiper motor onto the vehicle with two screws while keeping the shaft centered in the tailgate hole.
Tighten two screws to 6.5 N.m (57 lb in).
2. Connect the electrical connector to the controller.
3. Install the interior trim panel.
4. Install the spacer and the nut onto the vehicle.
