C 10 P/U 2WD V6-262 4.3L (1985)
Fig 5-40 All CK Models
4. Disconnect the hydraulic lines from the booster ports.
-
Plug all lines and the booster ports to prevent loss of fluid and to keep out foreign materials.
5. a. Remove booster pedal push rod cotter pin and washer and disconnect the push rod from the brake pedal.
b. Remove the lower dash trim, then lower the steering column.
c. Remove the booster bracket to dash panel or support bracket nuts and remove the booster assembly.
6. To install, reverse Steps 1-7 above.
-
Torque all hydraulic lines and attaching bolts to specifications.
-
Lubricate pedal rod and linkage pivot bolts, pins, sleeves and bushings with Delco Brake Lube (or equivalent).
