C 1500 Suburban 2WD V8-4.8L VIN V (2002)
Tape Player: Description and Operation
Base Level
1. In order to play a tape, the ignition switch must be in the ACCESSORY or RUN position and the receiver must be turned ON. Tapes are
end-loaded into the cassette player.
2. Insert the tape squarely through the door, exposed tape side of the cassette facing to the right.
3. When the tape is fully inserted, the AM/FM portion of the radio will turn off and the tape will begin playing.
4. The tape player works best with tapes that are 30 - 45 minutes long on each side. Longer running tapes may not work well in these players because
they are usually too thin.
5. Once the tape is playing, the volume, balance and fade knobs operate the same as with the radio. An arrow indicates which side of the tape is being
played.
FWD
1. Press the SEEK right arrow key in order to fast forward the tape.
2. Press the SEEK left arrow key in order to stop the fast forward operation.
REV
1. Press the SEEK left arrow key in order to rewind the tape.
2. Press the SEEK right arrow key in order to stop rewinding the tape.
RECALL
Press the volume control knob to change from one side of the tape to the other.
EJECT
Press the EJECT push button in order to remove the tape or in order to stop the tape and switch to the radio.
CLN
1. If CLN appears on the display, the cassette player needs to be cleaned in order to prevent damage to the tape player.
2. After cleaning the tape player, press and hold the EJECT button for 5 seconds in order to reset the CLN indicator.
3. The radio displays "- - -" in order to show that the indicator has been reset.
