C 1500 Suburban 2WD V8-4.8L VIN V (2002)
Trunk / Liftgate Handle: Service and Repair
LATCH CONTROL HANDLE REPLACEMENT - LEFT REAR DOOR
REMOVAL PROCEDURE
1. Remove the rear door trim panel, as necessary.
2. Pull back the water deflector, as necessary.
3. Disconnect the lower latch cable from the handle.
4. Remove the latch control handle screws.
5. Remove the latch control handle.
6. Disconnect the upper latch cable from the handle.
INSTALLATION PROCEDURE
1. Connect the upper latch cable.
2. Install the latch control handle.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the latch control handle screws.
Tighten
Tighten the screws to 9 N.m (80 lb in).
4. Connect the lower latch cable to handle.
5. Pull back the water deflector, as necessary. Refer to Water Deflector Replacement.
6. Install the rear door trim panel, as necessary.
