C 1500 Suburban 2WD V8-4.8L VIN V (2002)
7. Pull the cooling line straight out from the quick connect fitting.
8. Repeat this procedure to remove all the remaining cooling lines from quick connect fittings.
9. If equipped, remove the oil cooling lines from the auxiliary oil cooler.
10. Remove the oil cooling lines from the vehicle.
Installation Procedure
1. Install the transmission oil cooler lines to the vehicle.
Important:
^
Do not reuse any of the existing oil lines or oil line fittings if there is excessive corrosion.
^
Do not reuse any of the existing retaining rings that were removed from the existing quick connect fittings. All retaining rings being installed must
be new.
^
Ensure the following procedures are performed when installing the new retaining rings onto the fittings.
