C 1500 Suburban 2WD V8-5.3L VIN T (2001)
Output Shaft: Service and Repair
Manual Transmission - NV 4500
Transmission Housing Oil Seal Replacement (Rear Seal Replacement (2WD)
^
Tools Required
-
J 8614-01 Yoke Holder
-
J 6125-1B Slide Hammer
-
J 22834 Extension Housing Seal Installer
-
J 23129 Universal Seal Remover
-
J 38805 Output Shaft Nut Socket
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the rear propeller shaft.
3. Remove the following:
^
Remove the mainshaft nut.
^
Remove the washer.
^
Remove the rubber washer spline seal.
^
Remove the yoke.
4. Remove the rear oil seal from the rear case using the J 6125-B (1) and the J 23129 (2).
5. Remove the rear oil seal from the extension housing.
Installation Procedure
1. Using J22834 install the new rear oil seal into the extension housing.