C 1500 Suburban 2WD V8-5.3L VIN T (2001)
29. When using the extended method, use the edge of the quarter window or the inside edge of the reveal molding as a guide for the nozzle in order to
apply the urethane adhesive (1) to the inner surface of the quarter window (3).
If applying urethane adhesive to the inside edge of the quarter window reveal molding (1) use the quarter window reveal molding as a guide for the
nozzle.
30. With the aid of an assistant, use the suction cups in order to install the quarter window into the opening.
31. Align the tape lines on the quarter window and the body.
32. Press the quarter window firmly into place.
33. Tape the quarter window to the body in order to minimize movement until the urethane adhesive cures.
34. Clean any excess urethane adhesive from the body.
Important: Do not direct a hard stream of high pressure water to the freshly applied urethane adhesive.
35. Use a soft spray of warm water in order to immediately water test the quarter window window.
36. Inspect the quarter window for leaks.
37. If any leaks are found, use a plastic paddle in order to apply extra urethane adhesive at the leak point.
38. Retest the quarter window for leaks.
Caution: Insufficient curing of urethane adhesive may allow unrestrained occupants to be ejected from the vehicle resulting in personal
injury.
*
For the moisture-curing type of urethane adhesive, allow a minimum of 6 hours at 21°C (70°F) or greater and with at least 30 percent
relative humidity. Allow at least 24 hours for the complete curing of the urethane adhesive.
*
For the chemical-curing type of urethane adhesive, allow a minimum of 1 hour.
Do NOT physically disturb the repair area until after these minimum times have elapsed.
The following conditions must be maintained to properly cure the urethane adhesive:
1. Partially lower a door window in order to prevent pressure buildups when closing doors before the urethane adhesive cures.
2. Do not drive the vehicle until the urethane adhesive is cured. Refer to the above curing times.
3. Do not use compressed air in order to dry the urethane adhesive.
39. Install the right of left side applique.
40. Remove the protective coverings and tape from the vehicle and the headliner.
