C 1500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1997)
Crankshaft Main Bearing Seal: Service and Repair
Replacement, Engine Overhaul
REMOVAL
Remove the rear oil seal using a small screw driver. Do not reuse the old seal.
INSTALLATION
-
Tools Required
-
J 39084 Rear Crankshaft Oil Seal Installer, Or Equivalent
NOTE:
-
Coat the crankshaft surface with engine oil.
-
Lightly coat the lip of the new oil seal with engine oil or grease before installing the new oil seal.
-
Do not scratch or nick the sealing edge of the oil seal.
1. Install the oil seal, with the spring cavity facing the engine, onto the crankshaft.
2. Using The rear crankshaft oil seal installer, drive the seal into the crankshaft until the tool bottoms against the block and the rear crankshaft
bearing cap.