C 1500 Suburban 2WD V8-6.5L DSL Turbo VIN F (1997)
that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other
corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping
force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions
can help you avoid damage to parts and systems.
NOTE:
-
Lubricate the new seals with power steering fluid.
-
Apply a single layer of tape to the pitman arm shaft to avoid damaging the seals.
Install or connect the following:
1. Seal (5).
2. Washer (4) using J 6219 to seat the seal. The seal should be in far enough to install the snap ring.
3. Snap ring (3).
4. Center the steering wheel.
-
Turn the wheel until it stops.
-
Turn the wheel in the opposite direction until it stops, while counting the number of turns.
-
Turn the wheel back 1/2 the number of turns in the previous step.
5. Dust seal (2).
6. Pitman shaft boot (1).
7. Pitman arm.
8. Bleed the system. Refer to Bleeding.
