C 1500 Truck 2WD V6-4.3L VIN W (1996)
be off a tooth or more. Repeat the procedure again in order to achieve proper alignment.
10. Install the distributor clamp bolt. Tighten the distributor clamp bolt to 25 Nm (18 ft. lbs.).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants,
or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may
damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
11. Install the distributor cap and NEW distributor cap screws. Tighten the distributor cap screws to 2.4 Nm (21 in. lbs.).
