C 1500 Truck 2WD V6-4.3L VIN W (1996)
Distributor: Service and Repair
Distributor Disassembly and Assembly
NOTICE: The distributor driven gear can be installed in two positions. Make sure when installing the gear that the dimple found below the roll pin hole
in the gear is on the same side as the rotor segment. The dimple will not align directly with the rotor segment if not, the gear is Installed 180° off and a
no start condition may occur. Premature wear and damage may result.
Remove or Disconnect
1. Two screws holding the cap to the housing.
2. Cap from the housing.
3. Two screws from the rotor.
Vane Wheel In Distributor
4. Rotor.
