C 1500 Truck 2WD V6-4.3L VIN X (2003)
Note: Refer to Fastener Notice in Cautions and Notices.
2. Install the WSS mounting bolt.
-
Tighten the WSS mounting bolt to 18 N.m (13 lb ft).
3. Install the WSS cable mounting clip to the knuckle.
4. Install the WSS cable mounting clip to the upper control arm.
5. Install the WSS cable mounting clip to the frame attachment point.
6. Connect the WSS cable electrical connector.
7. Install the brake rotor (2) shown on the 1500 series. Refer to Brake Rotor Replacement - Front in Disc Brakes.
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
9. Perform the Diagnostic System Check - ABS.
