C 1500 Truck 2WD V6-4.3L VIN X (2003)
7. Install the transmission control lever to the manual shaft with the nut.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
8. Connect the PNP switch electrical connectors (2).
9. If equipped with 4WD, install the front propeller shaft.
10. Lower the vehicle.
11. Check the switch for proper operation. The engine must start in the park (P) or neutral (N) positions only. If proper operation of the switch can not
be obtained, replace the switch.
Valve Body and Pressure Switch Replacement
Valve Body and Pressure Switch Replacement
Removal Procedure
1. Ensure that removal of the valve body is necessary before proceeding.
