chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

General Information|Page 14854 > < Wheel Seal|Service and Repair|Page 14848
Page 1
background image

Vehicle Lifting: Service Precautions
General Information

CAUTION:

-

To avoid any vehicle damage, serious personal injury or death, always use the jackstands to support the vehicle when lifting the vehicle
with a jack.

-

To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is
supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed
.

NOTE:  Perform the following steps before beginning any vehicle lifting or jacking procedure:

-

Remove or secure all of the vehicle's contents in order to avoid any shifting or any movement that may occur during the vehicle lifting or jacking
procedure.

-

The lifting equipment or the jacking equipment weight rating must meet or exceed the weight of the vehicle and any vehicle contents.

-

The lifting equipment or the jacking equipment must meet the operational standards of the lifting equipment or jacking equipment's manufacturer.

-

Perform the vehicle lifting or jacking procedure on a clean, hard, dry, level surface.

-

Perform the vehicle lifting or jacking procedure only at the identified lift points. DO NOT allow the lifting equipment or jacking equipment to
contact any other vehicle components.

Failure to perform the previous steps could result in damage to the lifting equipment or the jacking equipment, the vehicle, and/or the vehicle's contents.

For lifting the vehicle, various lift points are recommended. Before you begin any lifting procedure, be sure the vehicle is on a clean, hard, level surface.
Be sure all the lifting equipment meets weight standards and is in good working order. Be sure all the vehicle loads are equally distributed and secure. If
you are only supporting the vehicle at the frame side rails, make sure the lifting equipment does not put too much stress on or weaken the frame side
rails.

If you use any other hoisting methods than those called out, take special care not to damage the fuel tanks, the exhaust system or the underbody.

General Information|Page 14854 > < Wheel Seal|Service and Repair|Page 14848