C 1500 Truck 2WD V6-4.3L VIN X (2003)
4.
Install the new propeller shaft assembly and the new center bearing. Refer to the applicable Propeller Shaft Replacement procedure in the
Propeller Shaft sub-section of the Service Information (SI).
Tighten
^
Tighten the propeller shaft flange bolts to 70 N.m (52 lb ft).
^
Tighten the center bearing support nuts to 40 N.m (30 lb ft).
5.
After completing the repair, operate the vehicle in order to verify that the condition has been corrected.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table shown.
DISCLAIMER
