C 1500 Truck 2WD V8-305 5.0L VIN M SFI (1997)
Seating The Boot In The Housing
4. Piston (9) and boot into caliper bore.
a. Push piston to the bottom of bore.
b. Seat boot in housing using tool No. J 36474, J 36475, J 38453 or equivalent.
5. Bleeder valve (11).
^
Tighten bleeder valve (11) to 13 Nm (115 inch lbs.).
Delco 3486
Tools Required:
J 36474-75 mm Boot Seal Installer or
J 36475-80 mm Boot Seal Installer or
J 38453-86 mm Boot Seal Installer
Caliper Components
Remove or Disconnect
1. Fluid from the caliper.
2. Pad the interior of the caliper with clean shop towels.
WARNING: Do not place your fingers in front of the piston in an attempt to catch, or protect it when applying compressed air. This could result
In serious Injury.
CAUTION: Use just enough air to ease the piston out of the bore. If the piston is blown out, even with the padding, It can be damaged.