C 1500 Truck 2WD V8-350 5.7L (1989)
Figure 3 - Adjust Thrust Bearing Preload
5.
Adjuster plug assembly (240) using J 7624.
-
Place J 29810 over the splined end of stub shaft (251) before installing the adjuster plug
(240). This will protect the stub shaft oil seal (242) from damage.
-
Adjust thrust bearing preload (Figure 3).
-
After adjusting thrust bearing preload, check the turning torque of the stub shaft (251) using
J 7754-01 (0-25 lbs.in. torque wrench) and a 12-point socket. A torque reading of 5-10 lbs. in. is desired. If this reading is not obtained, repeat
the adjustment procedure.
6.
Washer (243).
7.
Retaining ring (244).
IMPORTANT:
The retainer projections must not extend beyond the washer (243) when the retaining ring (244) is seated. The washer must be free
to rotate.
8.
Steering gear to vehicle.
Refer to section 3B1 of the appropriate C/K service manual for complete installation instructions.
SERVICE PARTS INFORMATION
P/N
Description
Year
Applications
