C 1500 Truck 2WD V8-350 5.7L VIN K TBI (1995)
4.
Install outboard pad in caliper. Ensure pad is seated fully into outboard arms of caliper. It may be necessary to tap the ears and bottom tab with a
hammer to seat the pad being careful not to hit the friction material.
5.
Place caliper assembly over rotor and position in steering knuckle. Ensure dust boot is not torn or improperly positioned by inboard pad during
caliper installation.
6.
Align caliper with steering knuckle abutment surfaces, then insert support key and spring between abutment surfaces at the trailing end of caliper
and steering knuckle. With a hammer and brass drift, drive caliper support key and spring into position, then install and torque support key
retaining screw to 12-18 ft. lbs.
7.
Refill master cylinder to within one inch of rim. Press brake pedal several times to seat pads.
8.
Install front wheels and lower vehicle.
