C 1500 Truck 2WD V8-350 5.7L VIN K TBI (1995)
1. Install transmission (20).
Important
-
Do not force the transmission into the clutch.
-
Do not let the transmission hang from the clutch, leave the jack under the transmission to support it.
NOTICE: When fasteners are removed, always reinstall them at the same location from which they were removed. If a fastener needs to be
replaced use the correct part number fastener for that application. If the correct part number fastener is not available, a fastener of equal
strength (or stronger) may be used. Fasteners that are not reused, and those requiring thread locking compound will be called out. The
correct torque value must be used when installing fasteners that require it. If these conditions are not followed, parts or system damage
could result.
2. Install washers (21) and bolts (19), as used.
3. Tighten bolts (19).
Refer to Specifications.
4. Install the crossmember.
-
Remove the jack.
5. Install bolts and the inspection cover (RPO MG5).
Tighten inspection cover bolts to 18 N.m (13 ft. lb.).
6. Install clutch slave cylinder.
7. Install electrical harnesses, as necessary.
8. Install exhaust pipes, if necessary.
9. Install parking brake and controls, if used.
10. Install transfer case, if used.
11. Install propeller shaft.
12. Lower the vehicle.
13. Install shift control lever, as used.
14. Install new transmission oil.
New Venture Gear 4500
Capacity: 3.78L (4.0 qts)
Lubricant type: Castrol Syntorq GL-4 Transmission Fluid
New Venture Gear 5LM60
Capacity: 1.98L (2.0 qts)
Lubricant type: Synchromesh Transmission Fluid T2850
