C 1500 Truck 2WD V8-393 6.5L DSL Turbo VIN S (1996)
Fig. 3 Ring Rear Removal.
b. Using drill 1/32 inch smaller than body of rivet, drill completely through each rivet securing ring gear,
Fig. 3.
c. Press out rivets and remove ring gear.
7. Inspect components as outlined and replace as needed.
ASSEMBLE
1. Install ring gear as follows:
a. Immerse ring gear in water heated to 160-180°F. for approximately 10 minutes.
b. Align gear over case pilot and install ring gear on differential case.
Gear should not be driven or pressed onto case as metal particles may
become lodged between gear and case causing excessive runout.
c. Install new ring gear retaining bolts from service package and torque bolts to 85-115 ft. lbs.
