C 1500 Truck 2WD V8-4.8L VIN V (2001)
10. Remove the steering knuckle.
Installation Procedure
1. Clean all grease and contaminants from the tapered section and the threads of the upper ball joint, the lower ball joint, and the tie rod end.
2. Clean and inspect the taper holes and the mounting surfaces of the steering knuckle. If any of the tapered holes are elongated, out of round, or
damaged, the replace the steering knuckle.
3. Install the steering knuckle.
Notice: Refer to Fastener Notice in Service Precautions.
4. Connect the lower ball joint to the steering knuckle and install the retaining nut.
-
Tighten the retaining nut to 100 Nm (74 ft. lbs.).
5. Connect the upper ball joint to the steering knuckle and install the retaining nut.
-
Tighten the retaining nut to 50 Nm (37 ft. lbs.).
6. Install the brake hose bracket retaining bolt to the knuckle.
-
Tighten the bolt to 9 Nm (80 inch lbs.).
7. Connect the outer tie rod to the steering knuckle. Refer to Tie Rod End Replacement - Outers or Tie Rod Replacement.
8. Install the wheel hub and bearing. Refer to Wheel Hub, Bearing, and Seal Replacement.
9. Connect the RTD link rod to the sensor (if equipped). Refer to Front Position Sensor Link Assembly Replacement - Electronic Suspension in Real
Time Damping.
10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation.
11. Remove the safety stands.
12. Lower the vehicle.
