C 1500 Truck 2WD V8-4.8L VIN V (2001)
1. Secure the clutch pedal to the brake pedal support module with 3 bolts.
^
Tighten the bolts to 50 Nm (38 ft. lbs.).
2. Position the clutch master cylinder to the vehicle.
3. Install the master cylinder to the dash panel.
4. Turn the master cylinder 45 degrees counter clockwise to lock the master cylinder.
5. Connect the wire harness to the clutch master cylinder.
6. Push the clutch pedal all the way down and connect the clutch pedal pocket to the pushrod bushing tabs and make sure the pushrod bushing snaps
into place to ensure clutch pedal operation.
7. Quick connect the hydraulic line to the master cylinder correctly.
8. Check the clutch pedal for travel, if the clutch pedal is hard to push, go back and quick connect the hydraulic line to ensure proper installation.
9. If needed, pump the clutch pedal 25 times to ensure proper operation to the clutch system.
10. Install the IP Carrier.
