C 1500 Truck 2WD V8-4.8L VIN V (2001)
Seals and Gaskets: Service and Repair
ZF S6-650 - Manual Transmission
Transmission Housing Oil Seal Replacement (Front Oil Seal)
^
Tools Required
-
J 23907 Slide Hammer
-
J 44748 Seal Remover
-
J 44731 Input Shaft Oil Seal Installer
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the rear propeller shaft.
3. Remove the transmission.
Important: The clutch actuator hose can remain attached to the clutch actuator. Disconnecting the hose from the clutch actuator will let the hydraulic
fluid drain from the clutch hydraulic system.
4. Remove the 2 clutch actuator bolts or nuts. Do not disconnect the hose from the actuator.
5. Remove the clutch actuator from the input shaft.
6. Remove the front oil seal using the J23907 (2) and the J 44748 (1).
Installation Procedure
