C 1500 Truck 2WD V8-4.8L VIN V (2001)
5. With the aid of an assistant, remove the window from the opening.
Installation Procedure
1. With the aid of an assistant, dry fit the window in the opening in order to determine the correct way to position the window in the opening.
2. Use masking tape in order to mark the location of the window in the opening.
3. Slit the masking tape at the top edge of the window.
4. With the aid of assistant and using suction cups remove the window from the opening.
5. Place the window inside up on a clean, protected surface.
6. Inspect for any of the following problems in order to help prevent future breakage of the window:
7. Inspect the following components for the causes of a broken window:
*
The flange of the window opening
*
The window reveal molding
8. Inspect for any of the following problems in order to help prevent future breakage of the window:
*
High weld
*
Solder spots
*
Hardened spot weld sealer
*
Any other obstruction or irregularity in the pinchweld flange
Important: If corrosion of the pinchweld flange is present, or if sheet metal repairs or replacements are required, the pinchweld flange
must be refinished in order to restore the bonding area strength. If paint repairs are required, mask the flange bonding area prior to
applying the color coat in order to provide a clean primer only surface. Materials such as BASF DE17(R), DuPont 2610(R),
Sherwin-Williams PSE 4600 and NP70(R) and Martin-Semour 5120 and 5130(R) products are approved for this application.
9. After repairing the opening as indicated, perform the following steps:
1. Inspect the condition of the window opening and the adhesive bead to determine which installation method should be used..
2. Remove no more of the urethane adhesive from the pinchweld than necessary in order to maintain the original shape. This will ensure the
proper clearance between the window and the pinchweld flange.
Important: Do not remove all traces of the adhesive. Remove all mounds or loose pieces of urethane adhesive.
3. If the original window is being reused remove all but a thin film of the existing urethane adhesive from the window surface by using a clean
utility knife or razor blade scraper.
4. If the extended method is being used remove all but approximately 2 mm (3/64 in) of the existing bead of adhesive from the pinchweld flange.
5. After repairing the opening, remove all traces of broken glass from the outer cowl panel, seats, floor and defroster ducts.
6. Clean around the edge of the inside surface of the window with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint
free cloth.
Caution: Refer to Window Retention Caution in Service Precautions.
10. Verify all primers and urethane adhesive are within expiration dates.
Caution: Refer to Failure to Prep Primer Caution in Service Precautions.
