C 1500 Truck 2WD V8-6.5L DSL Turbo VIN F (1998)
4. Install the EBCM gasket (3) onto the BPMV (4).
5. Insure gasket alignment is correct.
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
6. Install EBCM (2) onto BPMV (4).
7. install the four EBCM bolts (1).
Important: Do not reuse the old mounting bolts. Always install new bolts with the new EBCM.
^
Tighten the four bolts to 5 Nm (39 inch lbs.) in an X-pattern.
8. Install BPMV (4) to bracket (7).
9. Install the three BPMV to bracket retaining bolts (9).
^
Tighten the three bolts to 9 Nm (7 ft. lbs.).
10. Connect the four electrical connectors to the EBCM (2).
11. Install the ECU to the vehicle frame.
^
Tighten the three bolts to 12 Nm (9 ft. lbs.).
12. Install the right front, left front and rear brake pipes to the tube adapters (6).
^
Tighten the three brake pipe fittings to 30 Nm (22 ft. lbs.).
