C 1500 Truck 2WD V8-6.5L DSL Turbo VIN F (1998)
Stabilizer Link: Service and Repair
All Models Except C/K 3
REMOVAL PROCEDURE
1. Raise the vehicle on a hoist.
2. Remove the following parts from the stabilizer links:
^
The upper nuts
^
The washers
^
The bolts
3. Remove the bolts from the clamp insulators.
4. Remove the nuts and bolts from the stabilizer bracket to the frame.
INSTALLATION PROCEDURE
1. Install the nuts and the bolts to the stabilizer bracket and the frame.
Tighten
Tighten the nuts to 45 Nm (33 ft. lbs.).
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
2. Install the bolts to the insulators and the Clamps.
Tighten
Tighten the bolts to 34 Nm (25 ft. lbs.).
3. Install the nuts, the washers, and the bolts to the stabilizer links.
Tighten
Tighten the nuts to 45 Nm (33 ft. lbs.).
