C 20 3/4 Ton Pickup 2WD V8-350 5.7L VIN L 4-bbl (1983)
Steering Column: Service and Repair
Ignition Lock Cylinder
Fig. 6 Ignition lock installation. Exc. G & P models
EXC. 1980---85 G & 1980---87 P MODELS
1.
Remove steering wheel as outlined previously.
2.
Remove turn signal switch as outlined in ``Turn Signal Switch, Replace'' procedure.
3.
Place ignition switch in ``Run'' position, then remove lock cylinder retaining screw and lock cylinder.
4.
To install, rotate lock cylinder to stop, while holding housing as shown, Fig. 6. Align cylinder key with keyway in housing, then push lock cylinder
assembly into housing until fully seated.
5.
Install lock cylinder retaining screw. Torque screw to 40 inch lbs. for standard columns, or 22 inch lbs. for adjustable columns.
6.
Install buzzer switch, turn signal switch and steering wheel.
