C 2500 Suburban 2WD V8-454 7.4L VIN J SFI (1998)
2. Raise the vehicle.
3. Support the vehicle with safety stands.
4. Mark the relationship between the wheel and the hub.
5. Remove the tire and the wheel.
6. Position a C-clamp and tighten until the piston bottoms in the bore.
7. Remove the C-clamp.
8. Remove the brake hose.
9. Remove the bolt (2).
10. Remove the support key and the spring using a brass punch and a hammer to drive out the support key.
11. Remove the caliper assembly.
12. Inspect the inside of the caliper assembly for signs of fluid leakage.
13. Use a wire brush to remove any corrosion from the machined surfaces of the anchor plate and the caliper.
INSTALLATION PROCEDURE
